7
Installation Instruction
Unpacking the appliance
•
Before use, remove all packing materials, including bottom cushions, foam pads and tapes inside of the
refrigerator; tear off the protective film on the doors and the refrigerator body.
•
Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or watery places to prevent
rust or reduction of insulating effect.
•
Do not spray or wash the refrigerator; do not put the refrigerator in moist places easy to be splashed with
water so as not to affect the electrical insulation properties of the refrigerator.
•
The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat, and sturdy.
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated.
Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase
the electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 50mm of free space is left at both sides, 100mm at the rear and 10mm at the top
of the unit. This will allow cold air to circulate around the refrigerator and improve the efficiency of the cooling process.
Levelling the unit
Adjust the levelling of unit by rotating clockwise and counter clockwise the two levelling feet at the bottom of the unit. If
the unit is not properly levelled, the door and magnetic seal alignment will not be covered properly.
Summary of Contents for OBMF357W
Page 20: ...1...
