Omega OBFZ91B, Instruction Manual

Page: 13 / 15

13
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent
person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance does not
work
Mains plug is not plugged in
or is loose
Insert mains plug.
Fuse has blown or is
defective Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be corrected by an
electrician.
Appliance freezes
too much
Temperature is set too cold
or the appliance runs at
MAX
setting.
Turn the temperature regulator to a warmer
setting temporarily.
The food is not
frozen enough.
Temperature is not properly
adjusted.
Please look in the initial Temperature Setting section.
Door was open for an
extended period. Open the door only as long as necessary.
A large quantity of warm
food was placed in the
appliance within the last 24
hours. Turn the temperature regulation to a colder
setting temporarily.
The appliance is near a
heat source.
Please look in the installation location section.
Heavy build-up of
frost on the door
seal.
Door seal is not air-tight.
Carefully warm the leaking sections of the door seal
with a hair dryer (on a cool setting). At the same time
shape the warmed door seal by hand such that it sits
correctly.
Unusual noises
Appliance is not level. Re-adjust the feet.
The appliance is touching
the wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
If necessary, carefully bend the component out of
the way.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the
rating plate.