5
Installation
Unpacking the Appliance
Remove the external & internal packaging.
When unpacking the appliance please check for any damage. If damage is found, do not connect to the
power source and contact the Authorised Service Provider.
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation. Remove
any protective film from the outer surface.
Clean the interior surface with lukewarm water using a soft cloth.
Installing the Refrigerator
This appliance is designed to be free standing only, and should not be recessed or built
‐
in.
Place your appliance on a solid, level floor that is strong enough to support the appliance when it is fully
loaded. Use the adjustable feet at the bottom of the appliance to compensate for any unevenness of the
floor.
Allow at least 50 mm of space around the back and sides of the appliance, which allows the proper air
circulation, and at least 100 mm above the unit.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the appliance not to perform properly. Avoid locating the appliance in
moist areas.
Plug the appliance into an exclusive, properly installed
‐
grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an Authorised Service Centre.
After plugging the appliance into a wall outlet (220
‐
240V 50Hz), let the appliance at least 2 hours before
placing food in the freezer.
Reverse Door
Tool required: Philips screwdriver, flat bladed screwdriver, hexagonal spanner.
•
Ensure the unit is unplugged and empty.
•
To take the door off, it is necessary to tilt the unit backwards. Rest the unit on something solid so that it
will not slip during the door reversing process.
•
All parts removed must be saved to do the reinstallation of the door.
•
Do not lay the unit flat as this may damage the coolant system.
•
Two persons required for this installation.
1. Remove hinge cover and then unscrew hinge bracket.
2. Remove the top left screw cover.
Summary of Contents for OBFD127B
Page 1: ...Instruction Manual Bar Fridge OBFD127B OBFD127X...
Page 12: ...12 Data Label and Circuit Diagram...
Page 15: ...1...
