5
Installation Instructions
Fixing the rangehood to the wall:
1.
At the two range hood mounting points marked in H (refer to page 4), drill a small pilot hole using a Ø6 drill
bit, to a depth of approximately 40mm. After drilling, the distance between two mounting holes should be
260mm shown as A in Fig 1. below.
Fig 1.
2.
Fixing 2 plastic anchors into the holes drilled as above. Using a second person, carefully position the range
hood so the two “teardrops” line up with the plastic anchors.
3.
Using a screwdriver, fix the two Screws A (refer to page 3) and two washers into the plastic anchors, through
the teardrop fixing points on the range hood. Hands tighten.
4.
Check the rangehood body is level.
Note: Screws A x4 (refer to page 3) are supplied for installation into solid timber and/or Gib or similar
plasterboard. To affix to other types of wall surface, please contact professional rangehood installer.
Summary of Contents for OBC60BX
Page 1: ...1 Instruction Manual Box Canopy Rangehood OBC60BX OBC90BX...
Page 14: ......
