INSTALLATION INSTRUCTIONS
Before using your Wine Cooler:
Remove the exterior and interior packing.
Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water with a soft cloth.
Install the handle on the left side of the door.
Installation of your Wine Cooler
This appliance is designed to be for free standing installation or built-in.
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded.
To lever your Wine Cooler, adjust the leveling leg at the level position.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, radiator, electric
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption.
Avoid locating the unit in moist area.
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet.
Install or remove the shelf
To prevent the door gasket from damages, make sure the door is opened completely once pulling
the shelves out.
If a shelf needs to be removed, slide the shelf towards the gap located on both side and align it
with the shelf support (A). Then lift the shelf up and pull it out from the cabinet once disengaged.
A
A
5
