Omega MWTC-REC6, User Manual, Page: 7 / 16

MWTC-REC6/UWTC-REC6
4
From the “Tools” tab, select “Configure Receiver”. This will open the Setup and
Scaling window shown below. From here you must set the transceiver up to
match the same parameters you used when you setup and programmed your
wireless transmitter. Follow and set each required parameter.
Fig 4-4. Setup and Scaling Screen
Before you can make wireless measurements, your transceiver must be
configured properly. The following steps outline how to setup your transceiver.
(1) Operating Channels (Frequencies)
The default factory setting is channel “B”. This matches the default setting that
the MWTC Series Wireless Thermocouple connectors are also programmed to
from the factory. You can change the channel selection if you are experiencing a
disturbance at 915 Mhz. Keep in mind that the channel setting must match the
same channel setting on the transmitting wireless connector. You must have both
the connector and transceiver set to the same channel.
(2) Address
You must enter the same address number into this box that you set when
programming your wireless connector, click on the “Up” and “Down” buttons to
advance to a higher or lower address number.
(3) Timeout
The “Timeout” setting is used to set how long you want the unit to continue
showing the last reading of data when communication between the connector
and transceiver has been lost.
(4) Process Units
This setting allows you to change the current units of measurement. You can
change between °C, °F or °K
7
5
4
6
2
1
3