19 |
M 5 7 9 0
7 How to Pair a Sensing Device to a Layer N Gateway
Refer to either the Wireless Pairing or Wired Pairing instructions as applicable.
7.1
Wireless Pairing
Pairing your wireless Smart Interface (IF-006) or Smart Sensor is made easy with a one-button pairing system between
the IF-006 or Smart Sensor and the Layer N Gateway.
Important:
The pairing instructions for the SS-001-RUG differ from the standard wireless pairing procedure.
to pair an SS-001-RUG to your Layer N Gateway.
Step 1:
Push the pairing button once on your Smart Sensor or IF-006 device. The LED Status Indicator will blink green
indicating it is in Pairing Mode.
Step 2:
Quickly push the pairing button on the Layer N Gateway. The LED on the Gateway will blink green indicating
the Gateway is in Pairing Mode.
When the IF-006 or Smart Sensor has been successfully paired to the Layer N Gateway, the LED will stop
blinking on both devices.
7.1.1
SS-001-RUG Pairing
To pair an SS-001-RUG sensor to a Layer N Gateway, follow the instructions below:
Step 1:
Locate the small pinhole on the underside of the SS-001-RUG unit and insert a paperclip to press
the button once. The LED Status Indicator at the top of the unit will blink green once when
successfully completed.
Step 2:
Quickly push the pairing button on the Layer N Gateway. The LED on the Gateway will blink green
indicating the Gateway is in Pairing Mode.
When the SS-001-RUG has successfully been paired to the Gateway, the LED status indicator will briefly
flash orange before flashing green one more time.
Note:
Holding the pinhole button on the underside of the unit for longer than 5 seconds will reset the
sensor to its factory default settings.
