Omega FTB8000B, User Manual

Page: 5 / 8

CONNeCTIONS, mAINTeNANCe and RePAIR
Page 4
1 Lid and Hinge Pin Assembly 31616 31617
2 Lens Gasket Assembly 31619 31620
3 a Internal Assembly (gallons)
31621 31622
b Internal Assembly (cubic feet) 31625 31626
4 Coupling Assembly (incl 2 sets) 32156 32157
5 Coupling Gasket Assembly (incl 2) 31629 31630
6 Lens 31471 31471
7 Sensor Screw 31519 31519
a Single Reed Switch Sensor (PT) 31444 31444
b Double Reed Switch Sensor (PT) 31457 31457 8
c Single Hall-Effect Sensor (PR) 31612 31612
9
a Register (gallons) 31463 31464
b Register (cubic feet) 31473 31474
10 Internal Strainer 31483 31517
11 Tubular Strainer 31496 31497
1 Lid and Hinge Pin Assembly 31618 31618
2 Lens Gasket Assembly 31633 31633
3 a Internal Assembly (gallons)
31623 31624
b Internal Assembly (cubic feet) 31627 31628
4 Coupling Assembly (incl 2 sets) 32158 32159
5 Coupling Gasket Assembly (incl 2) 31631 31632
6 Lens 31471 31471
7 Sensor Screw 31519 31519
a Single Reed Switch Sensor (PT) 31444 31444
b Double Reed Switch Sensor (PT) 31457 31457 8
c Single Hall-Effect Sensor (PR) 31612 31612
9
a Register (gallons) 31465 31466
b Register (cubic feet) 31475 31476
10 Internal Strainer 31518 31518
11 Tubular Strainer 31498 31499
INTeRNAL PARTS RePLACemeNT. All of the internal parts
of an FTB8000B or FTB8000HW Series meter lift out as a
unit, after the top has been unscrewed. The lens can then
be removed and the internal assembly lifted out. If neces-
sary, turn the meter upside down and tap one end lightly on
a countertop to loosen the internals. The assembly can be
separated by hand.
1
3a
or
3b
6
7
8 a-c
9a
or
9b
10
11
4
5
(includes 2)
(includes 2 sets)
2
Blue - (No Connection)
Black - Common
Red - N O
Black - Common
Red - N O
Blue - N O
CONNeCTION DIAGRAmS
Diagram 1: Single Sensor Diagram 2: Dual Sensor
NOTe: The Dual Sensor is distinguished by a red stripe on the cable at
the base of the sensor.
PR:
Hall-Effect NOTe: PR not available with dual sensor
PT:
Reed Switch
PT:
Reed Switch
Black ( - )
White (signal)
Red (+)
3/4” 1”
1 1/2” 2”
To Distinguish Single Sensor From Dual:
Single: (if new from factory) blue wire is cut back on cable end.
Dual: A red stripe will be on cable near sensor.
Note: Dual sensor can be used as a single sensor also - use
either the red OR the blue wire w/black. If using it as a dual
sensor then connecting red and blue together will produce two
pulses with every revolution of magnet.
Except as noted, individual parts are not available.
FTB8000B Series
FTB8000B Series