Enable/Disable Procedure
1. Remove the battery cover and remove the 2 screws that are
at the top of the case.
2. Remove the 2 screws on the bottom or lower portion of the
case.
3. Gently remove the top half of the case from the bottom.
4. Figure 10a. shows the location of the HART™ jumpers.
Figure 10a.
4.4 Simulating a Transmitter
To have the calibrator supply a variable test current to a loop in place
of a transmitter, follow these steps:
1.
Select lower display from the Main Menu.
2.
Choose mA simulation from the primary parameters [mA 2W
SIM], and enter the desired current.
3.
Connect the 24V loop as shown in Figure 11.
Figure 11. Connections for Simulating a Transmitter
19