The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
A hose that a ttaches to a sink spr ay can burst if it is installed on the same water line as th e d ishwash er. If your sink
has one, it is recommended t hat the hose be d isco nnected and the hole plu gged .
Pull The safety supply hoses completely out from the storage compartment located at rear of
dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
The safety supply hose consists of the double walls. The hose's sy stem guarantees its i ntervent ion b y blocking the
flow of water in case of the supply hose breaking a nd when the air space between the supply hose itself a nd the outer
corruga ted hose is fu ll of wat er.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
Th e applian ce must be connecte d to the water mains using new hose-sets.
Th e old hose-sets should no t be reused.
Water pressure must b e between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department fo r advice.
Connect the cold water supply hose to a thread ed 3/4(inch) conn ector and make sure t hat i t is fastened tight ly in place.
If th e water p ipes are new or have not been use d for an e xtended period of time, let the water ru n to make sure that th e
water is clear and free of impurities. If this preca ution is not taken, there is a ri sk th at the water inlet can get blocked
and damage the appl iance.
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is no leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
