3
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list
and Figure 2 illustration. If any part is missing or damaged, do not attempt to assemble, install or operate the prod-
uct. Contact customer service for replacement parts.
aSSEMBLY INSTRUCTIONS
(ref. Figure 2)
A Hex Key-Philips Screwdriver Combo Tool (J) is provided and should be the only tool needed to complete assem-
bly.
1. Join frame sections by inserting front frame section (F) into channel sections of tool box subassembly (A). Line
up screw holes and thread screws (G) fitted with washers (D) into corresponding holes in channel sections. Do
not tighten screws yet.
2. Assemble a caster (E) and a tool tray (C or H) simultaneously. Position a caster stud into lower frame hole as
seen in Figure 2. Place tool tray into position by aligning the lower frame thru-hole with corresponding hole in
tool tray. Insert caster fastener into the swivel caster stud.
3. Repeat assembly above for remaining casters and tool tray. Once tool trays have been successfully installed,
hand tighten all assemblies with provided Combo Tool.
4. Ensure casters swivel and roll easily. Check Tool Box drawers for ease of movement.
To avoid personal injury and property damage:
•
Read, understand, and follow
all printed materials provided with and on this product before use.
•
do not
exceed rated capacity of
450
lbs
. Rated capacity consists of:
1
person, tools, equipment totaling
450
lbs.
• Use on smooth, level, seamless surfaces only!
• Sit down gently! Avoid shock loads caused by jumping or falling onto seat.
• Do not stand on this product.
• Keep out of the reach of children! This device is not appropriate for children’s use.
Package Contents List
Item
Description
Qty
A
Tool Box Sub-Assembly
1
B
Caster Fasteners
4
C
Rear Tool Tray
1
D
Flat Washer
2
E
Swivel Caster
4
F
Front Frame Section
1
G
#2 Philips Screw
2
H
Front Tool Tray
1
J
Hexhead-Philips Screwdriver Tool
1
Figure 2- Assembly
!
WARNING
OPERaTING INSTRUCTIONS
(Refer to Fig. 1, 2)
Understand and follow all warning information.
1. Load tool drawers carefully. Pull drawer open to remove, push to close.
2. After using a tool, wipe clean and dry before returning it to the tool box.
3. The toolbox seat is NOT suitable for storing flammable, combustible, or corrosive materials.
H
F
E
G
D
C
B
A
J
