11
12) Remote connector: It is to be connected with remote control box.
13) Torch terminal (+): It is to be linked to the torch terminal of wire feeder.
14)Earth terminal ( ): It should be connected to base metal
‐
Remote control box
A) Inching: Switch that feeds wire up to the tip of torch at the time of
replacing welding rod
B) Welding voltage: Welding voltage can be adjusted.
C) Welding current: Welding current can be adjusted.
4-3.Cautions in handling
1) Torch angle by welding direction Incline the torch 10 15° toward the
‐
welding direction, and afterward you can weld by ’forward method", or
’Backward method" In general, "Forward method' is used considering with
the friction of arc and protection of welded surface by gas.
2) Welding torch
If the welding torch is bent excessively, smooth wire feeding is not available, and welding
condition is damaged due to reduced current. Please do not bend cable forcefully.
3)Standard use rate
5. Safety instruction
1)Power source device : Install one on/off switch for one welder.
2)Terminal connection : Fasten the connection part for smooth current carrying in welding.
Loose fastening may cause cable damage or wasting power.
3)Ground : Apply class 3 grounding
4)Surrounding environment : Please avoid the location where moisture and dust is too much,
and surrounding temperature is too high. Select place where air is
ventilated well. Especially, ventilation relates to the use rate.
Use rate
350C
500 C
60%
350A
500A
70%
320A
440A
80%
280A
380A
90%
240A
340A
100%
200A
300A
Summary of Contents for 350C
Page 1: ......