3
PREPARATION
Assembly
(ref. Figs. 1 & 2)
1.
Make sure all parts are present.Insert extension tube
to the base.
2.
Insert roll pin into the bottom hole of the extension
tube to prevent inadvertent removal of the extension
tube.
Before Use
1.
Read this manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use before using the
product.
2.
Verify that the product and the application are
compatible
.
3.
Inspect jack stands before each use. Do not use if
there are bent, broken or cracked components noted (including labels). Ensure that all parts move freely.
4.
Consult the vehicle owners or service manual for location of proper lift and support points.
OPERATION
WARNING: Support areas of vehicle specified by vehicle manufacturer. Use ONLY on vehicles whose support
points are compatible with saddle of jack stand. Incompatibility may result in structural damage to vehicle and/
or jack stand.
1. Adjust saddle height by pulling up the extension tube, then insert the tube support bar through the hole on
extension tube.
2. Ensure that support bar is secured before loading. Insert support bar into the extension tube far enough to create
equal distance of bar extending from the extension tube on both sides.
3.
Carefully
position jack stands so that load is centered on stand’s saddle.
4.
Slowly
lower the vehicle onto the stands.
5. Check to ensure vehicle is secured before working on, around or under. Use wheel chocks on all unlifted wheels
in both directions to prevent inadvertent movement.
To lower load
WARNING:
Clear all tools and personnel before lowering load.
1. With suitable jack, raise vehicle clear of stands.
2. Carefully release support bar and allow extension tube to glide down to lowest position.
3. Carefully remove stands, then carefully lower
vehicle with lift device.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move freely. Do not apply oil or grease to any portion of this product.
If rust appears, sand affected area and cover with suitable utility paint.
Storage
Store stands in upright position and in a clean, dry area.
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Center load on saddle.
• Use as a matched pair only.
• Stands are not to be used to simultaneously
support both ends of a vehicle.
• No alteration shall be made to this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
WAR
NING
!
!
!
