KitchenMate
TM
Waste & Recycle Pullouts
WR7020MUF, WR7030MUF
Important Notes
• Always read the instructions completely and carefully before beginning assembly.
• Remove and check contents for damage and/or missing parts. Keep the original
cartons and packing materials, which are required for any authorized adjustment by
our dealers.
• These instructions are for reference only. Make sure installation procedures comply
with all applicable building codes in your area.
Form OME-058, 04/2009
©Omega National Products
Step 1:
Pre-drill two 3/32" holes 1/2" deep in each
stile. These should be drilled 4 1/2" down from
the top of the door opening and 3/8" back from
the face of the stiles (see figure 1).
4 1/2"
3/8"
Step 2:
Remove outer section of the drawer slides by
fully extending the slide and pushing up on the
black lever on the left slide and pushing down
on the black lever on the right slide, and then
pulling the slide apart while still pushing the
lever (see figure 2)..
Assembly Instructions
Figure 1
PUSH LEVER
PULL SLIDE
Figure 2
Step 3:
Mount the outer sections of the drawer slides
to the stiles with #6 x 1/2" Truss head screws
provided, using the pre-drilled holes made in
step 1.
Figure 3
