4
!
Be sure all tools and personnel are clear before lowering load.
Slowly open the release valve!
The
more you turn the handle knob counter-clockwise, the faster the load will come down.
Maintain control
of the rate of speed at which the load lowers at all times!
1. Raise load high enough to clear the jack stands.
2. Remove jack stands carefully (
always
used in pairs).
3.
Slowly
turn handle knob counter-clockwise, but no more than 1 full turn.
If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the jack stands.
c. Use the functioning jack to lower the vehicle.
4. After removing jack from under the vehicle, fully retract the jack to reduce ram exposure to rust and
contamination.
!
!
!
WARNING
•
Study, understand, and follow
all printed
materials provided with/on this product before use.
•
do not
exceed rated capacity.
•
This is a lifting device only!
•
Immediately
after lifting, support the load with
a pair
of appropriately rated jack stands.
• Use
only
on hard, level surface.
•
Lift only
on areas of the vehicle as specified by
the vehicle manufacturer.
•
never
wire, clamp or otherwise disable the lift
control valve to function by other than operator's
hand.
• No alterations shall be made to this product.
•
Failure
to heed these markings may
result
in
personal injury and/or property damage
.
To avoid
crushing and related injuries
:
•
never
work on, under or around a load supported
only by hydraulic jack.
•
Always
use adequately rated jack stands.
• Chock each unlifted tire in both directions.
•
do not
use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
•
Be alert
and
sober
when using this product. Do not
operate under the influence of drugs or alcohol.
!
WARNING
X
!
The wheels provided with this jack are for positioning the jack under a load
ONLY!
The wheels are
not
load wheels. Do not try to dolly or move the vehicle while the jack!
OPeRATIOn
(see Fig 1)
Lifting
note:
Jack is equipped with a handle position lock. To adjust the handle, release lock device by pulling the lever up,
lever is spring loaded and will lock into desired position. Ensure lever locking mechanism is fully engaged before
using jack.
1. Connect adequate air source to the air supply inlet.
2. Follow the vehicle manufacturer’s recommended guidelines for lifting. Engage the emergency brake and chock
each unlifted wheel in both directions to prevent inadvertent vehicle movement.
3.
Close the release valve by turning the handle knob clockwise until firm resistance is felt.
4. Center jack saddle under lift point, then squeeze the lift control valve until saddle contacts the lift point. To lift,
continue squeezing the lift control valve until load reaches desired height. Simply release your grip on the lift
control valve to end lift event.
5. Transfer the load
immediately
to appropriately rated jack stands.
Only attachments and/or adapters supplied by the manufacturer shall be used. Lift only on area of the
vehicle as specified by the vehicle manufacturer.
NEVER
use
hydraulic jack
as
a
stand alone device
!
ALWAYS
transfer the lifted load
IMMEDIATELY
to
a pair of appropriately rated jack stands. Use one pair of jack stands per vehicle. Rated capacity is per
pair only! Do not exceed rated capacity.
Lowering
