OMEGA ALTISE
HEATING
For greater economy, use the high heat setting initially and then turn down to the low heat setting when the
required temperature is reached. Please note that the fan speed remains the same when changing heat setting;
only the heating elements are adjusted. Note: The thermostat control should be at a higher temperature than the
room temperature, otherwise the elements and fan will not work.
To turn the heater off, turn the fan switch off (down).
THERMOSTAT CONTROL
The thermostat knob is used to control the room temperature. It acts as an on/off switch for the heating elements
and does not vary the heat from the elements. To set the temperature:
1.
Turn the thermostat knob fully clockwise until the maximum temperature setting is reached.
2.
Once the desired room temperature has been reached, very slowly turn the thermostat anti-clockwise until there
is an auditable click. The thermostat has turned off and the elements will stop producing heat. Turn the
thermostat knob slightly clockwise until the click is heard again and leave at that position.
3.
The heater elements will now turn off and on automatically, maintaining the room temperature you have set. To
increase or reduce this temperature, the thermostat control should be adjusted accordingly.
DOORS
There are 2 doors on this heater.
A)
The control panel door is just above the legs. It is opened by grasping the central knob and pulling down,
giving access to the control panel. Do not run the appliance with this door left open, as the heat from the
outlet may make the door and handle hot. To close, push back into position until the magnets hold it in
place.
B)
The main door is in front of the flame effect. This can be opened with the door handle at the right hand side.
There are no consumer adjustable components inside and the opening door is for cleaning or decorative
effect only. The door shuts in the same way as the control panel door.
