OMEGA ALTISE
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).
To reset your heater:
1.
Unplug the heater and wait for 45 minutes for the unit to cool down.
2.
Then, turn on the unit again and operate normally.
CLEANING & MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE HEATER IN WATER!
With the heater disconnected from the power, clean the exterior body of the heater with a soft damp cloth.
Always make sure that the heater is completely dry before connecting back to the mains supply. A vacuum
cleaner can be used to clean the inlets & outlets of dust & fluff. To clean behind a wall mounted unit, the
mounting clips can be disconnected & the heater removed. Please make sure the unit is properly resecured after.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the heater. NEVER
use ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the original packaging, in a cool, dry place.
WEEE WARNING
This product should not be disposed of with household waste. Please recycle where facilities exist and
check with your local authority for recycling advice.
HINTS & TIPS
Where possible, your electric panel convection heater should be connected to a power outlet that uses a separate
10 amp power circuit than other items. This will avoid overloading your household fuse.
In the event that your household fuse is overloaded and trips, please note this is normally caused by the use of
excessive power outlets at the same time your heater is operating (for example, a steam iron, kettle, toaster etc.).
Please ensure to check the use of the power circuit and adjust when heater is in use (i.e. turn off the heater when
boiling a kettle).
If your heater does not work:
Check that power is available to the heater & it is plugged in & turned on.
Check that the heater temperatures are set correctly for the ambient temperature.
Check that the thermal cut-out has not activated (see safety features).
Do not try to repair the heater.
Should you still experience difficulty contact Omega Altise Service for assistance.
It is important that you retain these instructions, proof of purchase as well as
other important documents about this product for future reference.
Due to continual product development, Omega Altise reserves the right to alter
specifications or appearances without notice.
Dispose of packaging responsibly – recycle where facilities are available.
