OMEGA ALTISE
OPERATING INSTRUCTIONS
TURNING ON & OFF
Once the unit is in “stand-by mode”, press the “power/set” button once to turn the unit on. The LED display will
show the current room temperature. Hold down again for 3-5 seconds and the unit will go back into “stand-by
mode” (only power indicator is lit). NOTE: If the power supply is interrupted while the unit is operating, the unit will
restart at using the same function when the power is reinstated.
POWER SETTINGS
There are 2 power settings, low & high. Once the unit is operating, the setting can be changed by pushing the
“power setting” button. Generally, start the unit using the high power setting (“HI” on the LED display), to heat the
room as fast as possible. Once the required temperature has been reached, the unit can be turned down to the low
power setting (“LO” on the LED display) to save power but keep the same temperature.
SETTING TEMPERATURES
While the unit is operating, press the “power/set” button once. The timer set indicator & LED display will start to
flash (showing the maximum temperature setting). To adjust the temperature, press the “up” & “down” buttons (the
range is 5°C to 30°C) while the LED is flashing until the required temperature is displayed. The timer set indicator
& LED display will stop flashing 5 seconds after the last button is pressed, indicating the change has been locked in,
and return to the room temperature display.
SETTING THE TIMER
While the unit is operating, press the “power/set” button twice. The timer set indicator & LED display will start to
flash indicating the timer length in hours (this will normally be “0” indicating the timer is off). Adjust the timer length
(in hours) by pressing the “up” & “down” buttons (the range is 24 hours down to 1 hour – 0 turns the timer off). The
timer set indicator & LED display will stop flashing 5 seconds after the last button is pressed, indicating the change
has been locked in, and return to the room temperature display. The timer set indicator will stay on while the timer
is set. Once the set time has elapsed, the unit will go into “stand-by mode”. To cancel or adjust the timer, repeat the
above & change the time setting.
CHILD LOCK FUNCTION
The control panel can be locked electronically by pressing the up and down buttons together until the lock symbol
appears on the LED (outer square). This stops all function buttons (except the main power switch) from operating.
Repeating the sequence will unlock the control panel. Note: Turning the power off & on or activating the tilt switch
will also disable the child lock.
MAIN POWER SWITCH
The main power switch is to the right of the control panel. After the heater is plugged in, switching this on this allows
the heater to function & switching it off stops all functions.
