6
Technical Specifications
Model
SE-US-0533-D
SE-US-0533-T
Stretch Film
18” maximum width
Hot Plate
6” x 15” / 152 x 381 mm
Electrical
110V / 60Hz / 1Ph
Weight
43 lbs. / 19.5 kg.
44 lbs. / 20 kg.
Packaging Weight
45 lbs. / 20 kg.
46 lbs. / 21 kg.
Dimensions (DWH)
22.25” x 26” x 18.50” / 565 x 660 x 470 mm
Packaging Dimensions
30” x 26” x 20” / 762 x 660 x 508 mm
Item Number
14430
14431
Installation
FILM CORE AXLE LOADING AND REPLACEMENT
Installing complete axle assembly
•
To install the assembly (1), simply position the assembly at the rear of the machine (2) with the removable
end cap (3) on the left side.
•
Insert two bolts (4) on each side through the machine base (2) and bearing block plates (5), slide on
washers and fasten washers with hex nuts (6).
Replacing the individual axle
•
To replace the axle, remove cap from end of one bolt (7)
and unscrew wing nut (8), then pull screw from bearing
block (9) and open to release the axle assembly, replace
axle assembly with removable cap.
Loading and adjusting axle for different width films
• Loosen the wing nuts and swing out upper bearing
blocks on both sides.
• Lift out the axle assembly, unscrew the movable end
cap and position fixed cap for film size being used and
secure with pin and o-ring (10).
• Place the core of the film against the fixed cap and feed
film from bottom of roll.
• Replace the movable end cap and screw tightly into film
core.
•
Replace the axle back into bearing blocks and then
tighten wing nuts to desired film tension.
