7
Operation
The machine is to be powered with by 110V AC with a grounded wire. When the power light flashes it means
that the machine is powered and in standby mode.
Press the power button, the power light turns on.
Press the pause button, all operation is paused and held. To continued the paused operation, press the start
button.
To cancel, press the rolling/cancel button. You can also cancel paused operations.
When the current state is in standby, the waste membrane roller will rotate continuously.
Auto button: when the button is held, the machine will switch between auto mode and half auto mode. When
the auto light is on, it is in auto mode. When the light is off, it is in half auto mode. If the button is not held
down, the machine will be in smart auxiliary function mode.
Reset button: press this button and the machine will be in counter hidden mode. Press this button again to go
back into counter mode. Hold down this button until you hear a beep, the current counter will be cleared.
SMART AUXILIARY FUNCTIONS
LEAKAGE PREVENTING FUNCTION
In standby mode, press the auto button, the auto single light flashes, that means the machine has entered
the smart auxiliary functions. After placing a container that isn’t sealing properly, press the start button. The
machine will start leakage preventing operations with the required parameters. Remove the container and the
machine will enter the standby state again.
AUTO CUTTER WASHING FUNCTION
In the standby state, install the drain plug into the outlet and use a napkin or other similar materials to seal the
outlet tightly. Put some warm water in the sink. Press and hold the pause button until it beeps, the machine
will enter auto cutter washing mode. The platform will slide out when the washing is finished. Press the cancel
button to return to the standby state.
