Omcan Santos 63, Instruction Manual

Page: 8 / 20

8
Operation
Maintenance
CHOICE OF TYPE OF GRIND
Turn the grind adjusting button (6) clockwise for a finer grind and anticlockwise for a coarser grind. The factory
setting is for the finest grind with the grinding-discs nearly touching each other.
SERVICING
Clean the coffee bean hopper (2), the grinder body tube (23) and the inside of the bag grip (13) from time to
time. Always turn the appliance off (switch (8) in position “0”) and unplug it.
CLEANING THE GRINDER BODY OUTLET TUBE:
The tube is behind the bag grip
Note: the bag grip is held on its 2 side supports by 2 springs. You are advised to hold the 2 side
supports with one hand when dismantling so that these 2 springs do not come out of their housing.
1. Press the lever of the bag grip (13) to access the 2 lower bag grip fixing screws (25), unscrew the 2 screws
(fig. F).
2. Release the bag grip while holding the 2 side supports and unscrew the 2 top bag grip fixing screws (24).
(fig. G).
3. Place the “bag grip + support” assembly gently on a flat surface.
4. Clean the tube (23) with a small brush or non-abrasive object. (fig. H).
5. Reassembling: proceed in reverse order.
MAINTENANCE
Prior to carrying out any intervention on the appliance, it must be disconnected from the mains without fail.
SPARE PARTS:
This machine requires no specific maintenance. The bearings are lubricated for life. If work is required to
replace worn parts such as the grinding-discs or the electric or other components, refer to the parts list (see
exploded view at the end of the manual).
IMPORTANT:
use of spare parts other than certified original Omcan parts is prohibited. Whenever ordering
spare parts (see references in the exploded view at the end of this manual), please quote the following:
• The type.
• The appliance serial number.
• The electrical specifications shown at the rear of the machine.
REPLACING GRINDING-DISCS
IMPORTANT:
always replace both 2 grindstones (21) at the same time. The 2 grinding-discs are identical