8
CLEANING
IMPORTANT:
•
In every case, the machine should be stopped and the machine’s power cable unplugged.
•
Cleaning with a water spray or pressure spray is not permitted.
SAFETY / MAINTENANCE
MOTOR OVERLOAD SAFETY FEATURE:
If the motor gets blocked (foreign or hard matter), the appliance will perform 2 successive blade rotation
direction changes to make it easier for the hard matter to go through. The appliance will then resume its normal
cycle. If the 2 direction changes are not enough to overcome this problem, the appliance will then go into
the safety state and the motor will stop. The safety state is signaled by simultaneously flashing of both push
buttons (4) and (5). In this case: To overcome the fault: remove the foreign matter from the crushing unit, then
Maintenance
Operation
CHOOSING THE SIZE OF CRUSHED ICE:
The appliance does not require any adjustment.
The left-hand button (5) is provided to obtain small-sized crushed ice.
The right-hand button (4) is provided to obtain big-sized crushed ice.
USING THE MANUAL OR AUTOMATIC MODE:
Manual mode
Prolonged pressing of one of the buttons (4 or 5) starts up the manual mode. The motor runs for as long as the
push button is pressed then stops as soon as it is released.
Automatic mode
Brief pressing of one of the buttons (4 or 5) starts up the automatic mode. The motor runs for a set
programmed time (1 minute) then stops.
Note: the timer cannot be adjusted. The preset time corresponds to complete crushing of the 1.3 kg of
ice (maximum hopper capacity).
During the automatic cycle, briefly pressing of the button for the size of crushed ice in progress (button lit up)
will stop the appliance (timer initialization). During the automatic cycle, briefly pressing of the button for the
other size of crushed ice in progress (button NOT lit up) will change the crushed ice size without initializing the
timer.
Opening the cover (1) during the automatic cycle will stop the motor. Closing the cover (1) will start the motor
back up. The cycle resumes where it was as soon as the cover is closed (timer not initialized on opening/
closing of cover).
