7
Handling and Assembly
Sufficient space
The distance from both sides and back of refrigerator
to wall or other substance must be no less than
10cm. The refrigeration capability may decrease if its
surrounding space is too small to circulate air.
Well ventilated
Always locate the refrigerator in an area with good
ventilation. When using for the first time, wait for 24
hours after handling to start.
Far from heat source
Never place the refrigerator direction under sunlight.
Never locate it near any heat source to prevent
reducing refrigeration capability.
No heavy load
Never put any heavy objects on top of the
refrigerator.
Do not make holes
Never make any holes on the refrigerator. Do not
attach any objects onto the refrigerator.
Stable Location
Unpack and place the refrigerator on flat and stable
ground.
Exclusive power socket
Normally, the power supply should be 100 – 110V, 60
Hz single phase AC with exclusive single phase two
pin receptacle.
Do not share the socket
Never let the refrigerator share a socket with another
appliance. The cable may become hot and this may
cause a fire.
Protect cables
Never break or damage the cables as this may cause
electrical shock.
No water flushing
Never give the refrigerator surface a flush otherwise
electrical shock may occur.
Avoid flammable and explosive objects
Never put any flammable or explosive items inside
the refrigerator such as gasoline or alcohol. Never put
any dangerous product nearby the refrigerator.
No spray
Do not spray the unit with a flammable substance
such as paint. This may result in a fire.
After power break
After power break or unplugging the refrigerator,
always wait at least 5 minutes before starting the
refrigerator again.
No medicine
No medicine is allowed to be kept inside the
refrigerator.
Operation
Before use:
Plug the refrigerator on 110V exclusive socket. After the refrigerator is running,
test the air suction to confirm that it is sufficiently cold. Then you may put food and
drinks inside.
Mechanical Temperature controller:
For normal use, put the controller at “MID-HIGH”. The evaporator might be
frosted if the controller is at the “FREEZE” setting and the refrigerator capability
