9
Operation
Maintenance
TEMPERATURE SETTING
Warning: it is advised to have qualified personnel set the temperature.
SET THE HIGHEST TEMPERATURE
1.
Press the SET button for three seconds, and then there will be “C” flashing on the display.
2.
Adjust the temperature by pressing the ▲ / ▼ buttons.
3.
Press the SET button to confirm.
SET THE INNER TEMPERATURE DIFFERENCE (LOWEST TEMPERATURE)
1.
Press SET and ▼ buttons simultaneously for seven seconds; “HY” will appear on the display.
2.
Press SET and ▼ buttons simultaneously for thirteen seconds; “L2” will appear on the display.
3.
Release the button; “HY” will appear on the display.
4.
Set the temperature difference by pressing the SET button first and then the ▲ / ▼ buttons.
5.
Press the SET button to confirm.
EXIT
Press SET and ▲ simultaneously for three seconds to exit; or just wait for thirteen seconds without pressing
any button and the system will exit automatically.
POWER ON AND TEST RUN
Power on equipment after it has been standing for over one hour.
1.
Please connect to a NEMA5-15R socket and ensure the unit is grounded.
2. Start running the cooling system by turning on the “Refrigeration” switch on the back of the unit.
3. Turn on the “Light” switch to control the LED lights.
Note: after start up, the temperature is 34°F ~ 41°F as the factory setting (please ask the installer
to adjust the temperature setting if you need to change it. It is recommended to have only qualified
persons adjust the temperature.
AREA
FREQUENCY
INSTRUCTIONS
Exterior
Daily
All Glass / Mirrors:
Clean side glass, front glass, glass shelves, and mirrors
with household or commercial glass cleaner. Clean out door track with a damp
cloth.
Exterior
Daily
Rear Sliding Door Glass:
Clean with household or commercial glass cleaner.
Exterior
Daily
End Panels, Front Panel:
Wipe off all surfaces with a mild detergent and
water solution and with a soft cloth.
