9
Installation
CABINET LOCATION GUIDELINES
•
Install the unit on strong and leveled surfaces
- unit may make unpleasant noises if surface is uneven
- unit may malfunction if surface is uneven
•
Install the unit in an indoor, well-ventilated area
- unit performs more efficiently in a well-ventilated area
- for best performance, please maintain clearance of 6” on the back of the unit
- outdoor use may cause decreased efficiency and damage to the unit
•
Avoid installation in a high humidity and/or dusty area
- humidity could cause unit to rust and decrease efficiency of the unit
- dust collected on condenser coil will cause unit to malfunction. Clean the condenser at least once a month
with a brush or clean cloth
• Select a location away from heat and moisture-generating equipment
- high ambient temperature will cause the compressor to overwork, leading to higher energy bills and
gradual breakdown of the unit.
ELECTRICAL
Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage
can detrimentally affect the refrigeration unit. All units should be plugged into a grounded and properly-sized
electrical outlet with appropriate overcurrent protection. Please refer to the electrical requirement on the
nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord.
REVERSING THE DOORS (OPTIONAL)
Note: This only applies to the single door units.
Only perform these steps with another person present to ensure the door does not fall over.
1. Open the door.
2. Remove the screws from the top panel, then open the top panel.
3. Remove the screws of the bottom louver, then remove the louver.
4. Unscrew all of the screws from the upper hinge
5. Unscrew all of the screws from the lower hinge and remove the door and hinges.
6.
Place the former upper hinge at the bottom of the unit, parallel to where the lower hinge is, do the same
with the former lower hinge except for the top. Screw the hinges into place.
7. Reassemble the door so it is facing the opposite direction.
8. Reassemble the top panel and the lower louver.
9. The door is now reversed.
Summary of Contents for RE-CN-0021-HC
