6
Maintenance
Be sure to always wash the grill plates after each use to remove any residue that may have accumulated.
For cleaning cast iron plate, please use warm soapy water while still warm. Do not use cold water on hot plate.
After cleaning, be sure the oil tray must be dry thoroughly before putting them back to the unit.
Do not immerse completely in water or any liquid to clean. The appliance is not to be cleaned with a water jet.
If the Omcan Contact Grill does not work, please check the following:
• The power supply is correct and switched on.
• The positions of switch and thermostat are correct.
Installation
Take out the Omcan Contact Grill from the packaging and locate the unit on a firm level surface.
When this appliance is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative
finished, etc., it is recommended that they be made of non-combustible material, if not, they shall be clad with
a suitable non-combustible heat-insulating material, and that the closet attention be paid to fire prevention
regulations.
Once the Contact Grill has been placed in position by consulting International Standards and regulations.
Cleaning the cast iron plate thoroughly is advised. Warm up the cast iron plate for 10 minutes until all smoke
and/or odor has dissipated. Switch off and unplug the unit, then use warm, soapy water to clean.
NEVER USE COLD WATER ON THE HOT PLATE.
Operation
Always preheat the grill before use until the ready light illuminates.
Lift the top grill plate, arrange food on the bottom plate and bring top plate back down to make contact with
food and begin cooking. If additional sandwiches are desired. Lower the lid to preserve the heat while you
prepare the additional sandwiches. When not cooking, the thermostat is turned off, unplug the unit.
