7
Installation
EQUIPMENT HOOK-UP
Electrical connection
The oven is not provided with a power supply cable. When connecting the appliance electrically, an automatic
RCD must be interposed with an opening distance between contacts of at least 0.1” / 3 mm. To connect the
appliance electrically it is essential to proceed in the following way:
•
Raise the cover of the oven.
•
Connect to the terminal block the power cable.
The power supply cable must be of H07-RNF type, with approved minimum cross section as prescribed by the
specific directive.
The electrical outlet must be easy to access, no moving should be necessary.
The electrical connection (plug) must be easily accessible, also following oven installation.
The distance between the machine and the socket must be adequate to not cause tension in the power supply
cable. In addition, the cable must not be located beneath the machine support base.
Installation must be executed by qualified personnel in compliance with local and national regulations.
OVEN POSITIONING
Ensure that the oven is put on a stand with the suitable carrying capacity and that it is flat. After unpacking the
oven from its packing, position it in prepared location, taking into account the minimum distances. Remove
possible protections in polystyrene and take off the protecting film (F) avoid use of tools which can damage the
surfaces.
Min. 7.9” / 20cm
Min. 7.9” / 20cm
Min. 7.9” / 20cm
Summary of Contents for PE-IT-0005
Page 12: ...12 Model PE IT 0005 40633 Model PE IT 0010 40634 Parts Breakdown...
Page 13: ...13 Model PE IT 0005 40633 Model PE IT 0010 40634 Parts Breakdown...
Page 14: ...14 Model PE IT 0005 40633 Model PE IT 0010 40634 Parts Breakdown...
Page 16: ...16 Model PE IT 0005 40633 Model PE IT 0010 40634 Electrical Schematics...
