Omcan MS-IT-0330-C, Instruction Manual

Page: 8 / 24

8
Maintenance
3. Rotate the slice thickness control to zero to make sure that the blade is covered by the slice thickness
plate.
4. Lift the sharpener cover.
5. Slip off completely the sharpener and spin it 180 degrees.
6. Put the sharpener device.
7. Push the green button to start the machine.
8. Sharpening: Press the sharpening wheel for about 10-15 seconds. Then press simultaneously also the
grinding stone for two seconds. Contemporaneously loosen the two grind stones. The sharpening and
honing take place then simultaneously.
WARNING: for a suitable effect please execute sharpening for 10-15” approx.
9. Press the red stop pushbutton.
10. Lift and rotate 180 degrees the sharpener and reallocate it into its initial position. Loosen the handle
rotating it clockwise to block the sharpener. Lower the sharpener cover.
SHARPENER DEVICE REMOVAL
To facilitate the cleaning of the sharpening grinder, remove the sharpener device pulling it upwards.
WARNING: Do not immerse in water or detergent the sharpening device.
CLEANING OF THE GRINDING WHEELS
To obtain an excellent sharpening the grinding wheel must always be clean. Remove dirt and grease with
alcohol and the supplied special brush.
MAINTENANCE
Disconnect the plug from the power point and take the slice thickness control on zero. We advise to wear
protective gloves during all the cleaning and maintenance operations.
ELECTRIC CABLE CHECK
Periodically check the electric cable wear.
SPARE PARTS
In case of parts replacement, ask only original spare parts.
CLEANING
If you do not use the machine for long time, always carry out a deep cleaning of the machine before using it.
For the cleaning of all the open parts use a dampen cloth.
WARNING: Do not use water jet.