Omcan GR-IT-1000-C, Instruction Manual

Page: 14 / 32

14
Maintenance
The adjustments must only be made with the machine disconnected from the electricity mains.
Do not perform any operations without having received specific authorisation and adequate training on
the operating procedures as well as being informed about the possible dangers.
CHANGING THE CUTTING WIRE
To change the cutting wire proceed as follows:
• Remove the wire, using the tools supplied (A and B).
• Hook the two cables (1) with the ends of the tool (A).
• Loosen the dowel (6) in the bottom of the wire hooking pawl (2) pressing down (3) until the wire is released
(4); repeat this on the other side.
• To put the new wire in place (C) insert (5) the wire in place on the cylinder (2) and retighten the dowel (6)
with the Allen wrench (D); repeat on the other side