8
Maintenance
• The freezer should be cleaned regularly. When cleaning, turn off the power, take out the food in the cabinet,
clean the inside using water or a little neutral detergent.
•
Do not use boiling water, acid, chemical diluents, petrol and oil, or dirt-removing powder.
•
Dry it after cleaning.
•
Use light soap water when cleaning the door seal, apply a little of talcum powder on it after natural drying to
extend its service life.
•
Use soft cloth with water or a little detergent to clean the out surface. Note, keeping the power supply and
lower part of connect wires away from water to avoid electricity leakage.
•
Except common breakdowns, those who are not service technician should not take apart and repair the
freezer on their own so as to avoid worsening the trouble. Unauthorized repair of electrical part such as
compressor, temperature controller is forbidden.
DEFROSTING
• Defrost for better freezing efficiency when the frost film in the cabinet is 4-5mm thick.
• When defrosting, turn off the power, take out the frozen foods, open the door for warming and melting. Use
a soft cloth to absorb water and clean it up.
• Do not use sharp metal tools such as steel brush to clean the frost film when defrosting so as to avoid
evaporator damage.
Troubleshooting
Problem
Possible Cause
Solution
The indicator is not on.
The compressor does not start.
The plug isn’t fully connected to
the socket.
Replug it.
No power.
Connect the socket with power.
The indicator is on, but the
compressor doesn’t work and
buzzes only.
The power voltage is <98V.
Put a power-regulater more than
1000W power together.
The compressor stops a minute
after start, and restart after a few
minutes, and so repeatedly.
The power voltage is >132V.
Put a power-regulater more than
1000W power together.
The compressor works normally,
but the temperature in the cabinet
lowers too slowly.
The door is opened too frequently.
Reduce open times.
The food in the cabinet is too
much, or placed improperly.
Place foods properly, keep space
between them for ventilation of
cold air.
The frost film is too thick.
Take out foods and defrost.
The surface of the condenser is
too dirty.
Stop and clean the condenser.
The door seals badly.
Adjust the door seal.
Summary of Contents for FR-CN-0142
