7
Installation
Operation
number correspond to the features shown in the consignment and delivery note.
OPERATION CHECKS
Check the proper functioning of the machine according as follows:
1.
Press the start button “I” and the stop button “0”.
2. Check whether the machine stops after the lid has been removed.
3. In case of a CUTTER equipped with a speed dial knob, check whether the number of rotations increases
by adjusting the knob clockwise.
CONTROLS
Controls are placed on the CUTTER body as shown in the picture.
NOTE: The speed dial knob (1) is installed only in the vv model.
1.
Dial knob to set the number of rotations.
2.
Start button “I”.
3.
Stop button “0”.
LOADING OF THE PRODUCT
NOTE: Products to be cut must be loaded onto the basin when the motor is switched off and in case of
a CUTTER vv after the speed dial knob has been set to the “0” position.
The procedure is as follows:
1. Rotate the arm counterclockwise in order to remove the lid.
2. Load the product into the basin and be careful of the two blades; if the product is in large pieces, break
them into smaller pieces by hand before putting them onto the basin.
WARNING: Do not fill more than 1/2 of the tank.
3. To avoid accidents, position yourself safely: your body must be perpendicular to the working table; and your
hands must not force on the machine or stop its movement.
Never lean on the machine and avoid any direct contact with it.
4. Re-position the lid and rotate the arm to closed position.
5. Start the machine by pushing the start button “I”.
6. Don’t use the machine at low speed for long time.
7. Load additional quantities of product through the upper hole during cutting, if necessary.
8. Once the product has been cut, stop the machine by pushing the red stop button. If the CUTTER is
provided with a speed dial knob, adjust it to the “0” position and then stop the machine.
9.
The cutter is equipped with a device that switches it off after 30 seconds, if the cutter has been used at
minimum speed for more than 30 seconds. This device avoids motor overheating. If you use the cutter at
low speed, rest it for at least 30 seconds.
