13
Maintenance
350°F ±15°F. If not, continue to Step 4.
4. a. Carefully loosen the knob set screw. DO NOT allow the knob to turn. Carefully remove the knob from the
thermostat shaft, exposing the temperature dial.
b. Loosen screws on the temperature dial and adjust to that the temperature indicated by the knob arrow
matches the griddle plate temperature reading. Knob will have to be placed back on the shaft to verify
adjustment.
IMPORTANT: NEVER ADJUST THE SCREW IN THE CENTER OF THE THERMOSTAT SHAFT. This
will ruin the factory calibration; the thermostat will no longer operate properly and may need to be
replaced.
5. Once calibration is achieved, tighten the temperature dial screws and knob set screws.
MAINTENANCE
Warning: The griddle and its parts are hot. Use care when operating, cleaning or servicing the griddle.
LUBRICATION
There are no parts on this griddle that require lubrication.
VENT
Daily, when the griddle is cool, check the flue and clear any obstructions.
SERVICE AND PARTS INFORMATION
Contact the Service Agency in your area to obtain service and parts information. For a complete listing of
Service and Parts depots refer to supplier. When calling for service, the following information should be
available from the appliance identification plate: Model Number, Serial Number and Gas Type.
LEVELING
Griddle must be level (side-to-side and front-to-back) during operation to ensure proper performance. Improper
leveling can result in uneven temperature distribution, cold spots, and possibly damaged components.
1. Place a level on the griddle.
2. Adjust legs by turning the bullet feet at the bottom of each leg. Using pliers or a crescent wrench, turn the
feet counter-clockwise to increase height, and clockwise to decrease height until leveling is achieved. Do
not extend the legs more than 1-¾”.
PILOT ADJUSTMENT
Using a flathead screwdriver, turn the slotted hex-head pilot adjustment screw clockwise to decrease the flame,
and counterclockwise to increase the flame.
SHUTDOWN OF GRIDDLE
1.
Turn thermostats to the OFF position to cut off burners.
2. The pilots will remain lit and monitored by the safety valve as long as the main gas supply is on.
EXTENDED SHUTDOWN
1.
Shut off the main gas supply valve.
Apply a heavy coat of vegetable oil over the griddle plate to inhibit rust.
