10
Instructions for Field Conversion between LP & NG
CAUTION: ENSURE THE GAS SUPPLY IS SHUT OFF AT THE MANUAL SHUT OFF
VALVE BEFORE PROCEEDING WITH THE CONVERSION.
1. Switch off the gas at the main supply valve and allow the unit to cool down before commencing with the
conversion.
2. Lift off the complete grill plate assembly to expose the burners and valves.
3. Remove the burners by loosening the fastening nuts located under the rear of the burner, lift the rear of the
burner and slide backwards.
4.
The brass orifice located on the end of the control valve may now be loosened and removed using a 1/2”
wrench. Replace with the new orifice from the conversion kit, first applying a small amount of jointing paste
to the threat on the end of the valve, this will ensure a good gas tight seal.
5.
Replace the burner by sliding the open end over the orifice and then locating the M5 stud through the slot
in the support bracket. Secure by replacing the M5 nut.
