6
Technical Specifications
Installation
Model
BS-CN-1651-T
BS-CN-2020
BS-CN-2400
Electrical
110V / 60Hz / 1
220V / 60Hz / 1
Power
750W
1500W
2200W
Diameter of Wheel
8.3” / 211mm
9.8” / 250mm
11.8” / 300mm
Length of Saw
65” / 1651mm
79.5” / 2020mm
94.5” / 2400mm
Material of Saw
High-Carbon Steel
Line Speed of Saw
Blade
16m/s
18.8m/s
22.6m/s
Dimensions of Working
Table
17.3” x 18.3”
440 x 465mm
22.2” x 26.3”
565 x 668mm
30.2” x 29.1”
767 x 738mm
Thickness of Table
0.1” / 3mm
0.2” / 4mm
Max Slicing Thickness
6.3” / 161mm
8” / 202mm
9.9” / 252mm
Max Height of Cutting
9.4” / 238mm
12” / 304mm
14” / 355mm
Speed of Motor
1400r/min
Weight
89.5 lbs. / 40.6 kgs.
265.4 lbs. / 120.4 kgs.
310.9 lbs. / 141 kgs.
Packaging Weight
126.1 lbs. / 57.2 kgs.
340.8 lbs. / 154.6 kgs.
409 lbs. / 185.5 kgs.
Packaging Dimensions
19.7” x 20.5” x 40.2”
550 x 520 x 1020mm
26.4” x 29.3” x 63”
670 x 745 x 1600mm
32.3” x 34.4” x 68.3”
820 x 875 x 1735mm
Item Number
46785
46786
46787
Place the machine in a stable and flat location. Especially when assembling or disassembling. If the surface
is not completely flat,you can adjust the rubber feet to compensate. Please ensure that the power supply is
the same as indicated on the rating label and is properly grounded. Please ensure that the power cable is
long enough to reach the power source comfortably and that the cable is not damaged. When the machine is
opened by the user, please inspect the saw belt length on the top and bottom block, it is must be parallel with
the edge of the block. Close the machine’s door and connect to the power source, turn on the green switch,
and then the machine is ready for operation. If you turn off the red switch, the machine will shut down.
PLEASE ENSURE THE BELOW AT ALL TIMES:
1.
The machine should be running correctly (clockwise).
2. If the saw blade is loose, please turn the handle on the top until tightened. When properly tightened, the
machine will slice correctly and can now be operated safely.
NOTES:
1. During installation, please pay attention to direction of the blade, the blade must be facing the correct
direction.
2. The scraper must be installed properly with the saw blade. If it is improperly installed, it will cause more
