11
Installation
to avoid problems of this nature.
8. Air vent on door must be provided for built-in cabinet when a wood door installed.
In hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x 40mm MUST be cut out
at the rear top of the back partitioning or at the top of either side of the partitioning, allowing cool fresh air full
access to flow into the 30mm gap located at the rear of the cabinet.
This air vent or grid must not be opened on the same side as other appliances such as ovens or an area that
is sealed and without access to fresh cool air. Failing to comply with the above specifications could result in
WARRANTY void.
REVERSING OF THE DOOR
1. Depending on the model and the type of handle of the cabinet, you may need to rotate the door 180
degrees or symmetrically change the direction of the door (according to the product’s own configuration).
2. The door may be irreversible depending on the type of handles of the cabinet, or the door may need to be
opened and replaced when ordering.
Warning: To avoid accidents during
the process of changing the door, we
recommend that you get assistance. The
glass door is heavy and may cause injury
if dropped.
1. To put the cabinet on open operation
place, the door opened to the maximum
angle.
2.
Use small knife (2) to take off the
decorative nail (1) on opposite side
(Drawing 1).
3.
Use the inner six angle screwdriver (Tool
5) to disassemble the screws (4) of drop-
proof device (3), then remove the drop-
proof device (Drawing 1).
4.
Hold the door, use six angle screwdriver
(Tool 5) to screw out the door shaft core
(6) from the two ends of the top of the
door. Take out the door and set aside
(Drawing 2).
5. Discharge the upper and lower door
hinge (7) (8) by M5 inner six angle
screwdriver (Tool 5), then to assemble
the door hinge on the opposite side
(Drawing 3 and 4).
6.
Reverse the door 180 degrees, then