9
Troubleshooting
DIGITAL CONTROLLER TROUBLESHOOTING
Fault Code
Causes
Solutions
EE1
Open or short circuit of
temperature probe.
Check if the plug on the mainboard is loose, or
change the temperature probe.
EE2
Open or short circuit of defrosting
probe.
Check if the plug on the mainboard is loose, or
change the defrosting probe.
EE3
Open or short circuit of overheating
probe.
Check if the plug on the mainboard is loose, or
change the overheating probe.
EE4
Overheating probe starts
protecting program 58°C / 136.4°F.
Clean the condenser.
Repair or replace the Condenser motor.
Ensure the unit is at least 50cm away from the wall.
Ensure the ambient temperature is within the range
specified on the rating label.
Maintenance
1. Cabinet Cleaning. The product should be cleaned once a week with the power supply disconnected.
Please use mild detergent and water. Do not wash it directly with a water faucet or by submerging the unit
in any way.
2. De-dusting the condenser. The condenser should be cleaned every three months with the power supply
disconnected. To clean the condenser, use a wire brush carefully.
3.
Leaking check. Observe all connectors and welded joints for oil stains, is oil stains are visible please call
Omcan.
4.
Frequently observe the operation of the product. In case of any abnormal noise or smell, cut off the power
supply immediately and call professionals. Do not restart the product before source of trouble is found.
5.
We will not be responsible for any accidents acquired through failure to follow previous notices.
Operation
•
To avoid scalding, never touch the compressor.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly
qualified persons in order to avoid hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
