8
Troubleshooting
Problem
Possible Causes
The machine does not work.
Is the power supply on?
Is the power switch on?
Has the safety guard been put down?
Lift safety guard, start level and check if you hear a
click from the limit switch.
Electrical cabinet continuously vibrates.
Is the belt loose?
Are the wires improperly connected?
Is there something inside the electrical cabinet?
The machine only works on one side.
Has the breaker failed?
The wiring of the Level or limit switch failed?
Is the wiring of the motor incorrect?
Is the electricity not three phase?
One conveyor side works while the other side has
stopped.
The gear is worn out.
Conveyor belt is not tight enough.
Thickness handle cannot stay fixed and falls
downward.
If machine runs smoothly when toward the right-hand
side but does not when toward left-hand side, this
means the chain inside the rear of the machine body
is too loose. Set the handle at a scale of 15-20, and
use a screw driver to open the cover. Apply spanner
to adjust motor plate to tighten chain. Check if handle
can be operated smoothly.
Conveyor moves toward one side during production.
Adjusting the nuts to let the belt move straight. For
example, if belt moves toward the rear side, loosen
the front nut. When adjusting the nuts, make sure
that the speed of belt is the same as roller and there
are no gaps between the roller and belt.
Noise from roller.
Bearing wore out.
If noise comes from the pressing roller & scraper and
conveyor, something is stuck on the active roller. To
clean the active roller simply lift the table. Refer to
assembly drawing for active roller and passive roller
position.
