9
Installation
ELECTRIC INSTALLATION
The equipment has been designed to operate 230 Volts. When you receive the equipment check the voltage
indicated on the cord label. The power plug has 3 pins the middle pin is the ground. All the 3 pins must be
properly connected.
IMPORTANT:
Make sure the network voltage is the same as indicated on the cord label.
BLADE
The Blade shall be installed with the teeth turned toward the saw front side, and downward. To stretch the
blade #08 (Pic.01) turn clockwise the Blade Tension Regulator Handle #01 (Pic.01) until it stops. The quantity
of teeth in a band saw will influence both, the cutting speed and the quantity of remains produced during the
cutting procedure.
BLADE GUIDE
With the saw switched OFF turn the Handle #06 (Pic.01) counter clockwise to loose the Blade Guide #07
(Pic.01). Adjust the Blade Guide height to meet the meat piece thickness, and not more. Then tighten the
handle #06 (Pic.01).
TRAY
The Saw has a Tray #16 (Pic.01) placed under the saw, to collect residues. To remove the tray pull it sideways
until it is completely out. To replace it follow the inverse procedure and push until it is completely in.
SCRAPERS
The saw has two scrapers, the wheel scraper #18 (Pic.01) and the blade scraper #19 (Pic.01).
The Wheel Scraper:
This scraper cleans the bone dust or the residues from the Lower Wheel during
operation. The scraper may be removed for cleaning (see Cleaning).
The Blade Scraper:
This scraper cleans the bone dust or the residues from the blade during the operation.
The scraper may be removed for cleaning (see Cleaning).
LOWER WHEEL
The Lower Wheel is assembled on the lower bearing shaft and fixed by the staple #10 (Pic.01). The staple
shall always be placed in the shaft slit. The lower wheel may be removed for cleaning after removing the blade
(see Cleaning).
UPPER WHEEL
The Upper Wheel #05 (Pic.01) frame has its own shaft and bearings. Therefore the Upper Wheel has to be
removed with the shaft and bearing for cleaning (see Cleaning), only after the Blade has been taken off.
