8
Installation and Operation
Maintenance
• See fig 3, turn the hand grip to the level position, pull out pin 7 and save pin 7 with care for next use.
TEST OF HAND PALLET TRUCK
• After the truck is assembled, try to rock the hand grip and operate different positions of control handle knob
10 to examine the lifting, free position and dropping and check that whether the different positions are
normal or not. See fig 5.
• The screw 9 in fig 4 is used to adjust the truck situation. When the truck body drops immediately after
it is lifted, you should turn the screw 9 a little counter-clockwise. And then try the truck again until truck
body could lift normally. If the truck body couldn’t drop after it is lifted, you should turn the screw 9 a
little clockwise. And then try to operate truck again until the truck body could drop normally. The external
hexagon nut 8 at screw 9 plays the locking function in the truck. So you should undo the external hexagon
nut 10 before adjustment. And screw down the nut 8 after you finish the adjustment.
OPERATION
•
Before operation of the hand pallet truck please make sure that whether the cargo weight exceeds the
rated load or not.
• The cargo loading type is shown as fig 6.
• See fig 5, when hand knob 10 is placed on the lift position, the truck will be in a state of lift. At this time, if
you rock the hand grip, the truck will be lifted.
• See fig 5, when hand knob 10 is placed on the free position, the truck will travel. At this time, if you rock the
hand grip, the truck will neither lift nor drop. Then, you can use the truck to move the cargo.
• See fig 5, when the hand knob 10 is placed on the drop position, truck forks will drop. At this time, the truck
forks will drop automatically.
• See fig 5, when the hand knob 12 is placed blow, the truck will be in a state of free walking.
• See fig 5, when the hand knob 12 is placed above, the truck will be in a state of brake.
• See fig 5, hand knob 11 is used for release brake.
The routine check should be carried out daily and every abnormal phenomenon should be dealt with
immediately. Please do not use faulty truck in order to prolong the service life. If there are any faults, please
consult the professional. If it is necessary to replace the parts, the new parts should be provided by the original
manufacturer. All the rotary joints should renew the motor oil every three months. Especially pay more attention
to the place between wheel and axis. Make sure that there is not any yarn or other rags in order to keep all
wheels running with handiness.
DISPOSAL OF WASTE OIL
The waste hydraulic oil shall be disposed in terms of relative laws. And it is forbidden to pouring out anywhere.
