omake Omk.WFL21.E15.0101.Z5F, User Manual

Page: 29 / 37

27
- Usage:
When the device is on, the R2(10A) relay output is activated by keeping the start button
pressed. The relay output time is as long as the time set on the timer screen. Pressing
the stop button stops the time.
R1(30A) relay output becomes active according to the set
degree set on the temperature screen. When it reaches the set point, the R1 relay stops
giving output.
When you start the device for the first time, an odor and smoke may occur due to insulation
material and heating elements. Therefore, before starting to use, set all thermostats to
maximum and run the device idle for 30 minutes. After 30 minutes, let the device cool down.
Make sure that the surfaces that will come into contact with food are clean.
Pour the mortar prepared for the waffle in an amount that will not overflow from the mold.
Spread the mortar on the mold with a spatula. Close the top lid on the mortar and cook.
-Service Menu;
-When the device is off, the service menu is accessed by pressing and holding the
button for 5 seconds.
-When in the service menu, it is possible to switch between parameters with the help of
the buttons next to the temperature screen. Parameter value range is
adjusted with the help of buttons next to the time display.
-Press the button to exit without saving the change in the parameter menu, and the
button to exit by saving.
Parameter Explanation Min Value Max Value Unit Factory settings

Hysteresis
   

PCB temperature
− −  −

Temperature Display Unit
  − 

Thermocouple Type
Selection
  −

Maximum Set Temperature
to be Adjusted
   

Maximum To Be
Adjusted
Time
 
Minute

Table 1: Service Parameters