OM POWER OM4000A, Instruction Manual

Page: 18 / 36

18
By scrolling UP / DWN select desired Baud Rate which must be the same as baud rate used by
your transceiver (please refer to your transceiver user manual). To confirm your selection press
SET.
When using Yaesu TCVR you need to configure the STOP BIT parameter correctly and confirm
selection with SET.
The communication settings menu can be left by pressing the AUTO button. The amplifier will
enter AUTO mode only if all settings are correct and connection has been established with your
transceiver. You can verify that the correct frequency and transceiver type is shown on the LCD
display.
5.2.2. Connection with not supported TCVRs
For communication with TCVRs, that are not supported by OM4000A (for example JST-245 and
older types of Kenwood), an external IF-232 converter is to be used. You can also use devices
from several companies that produce compatible CI-V output which deliver frequency
information in ICOM format through the CI-V output. Then the PA will be connected in the
following configuration:
JST-245 <> DB37- JST-245 cable <> MKII ( or other device which has a CI-V output ) <> PC.
OM4000A is connected to the CI-V output of the CI-V device (MicroHam for example).
mmm Confirm CHOOSE TCVR by pressing SET
again and scroll UP / DWN to your
transceiver type. Confirm the selection by
pressing SET.
mmm
TCVR is connected via CI-V of MKII.
Transceiver frequency is visible on the
display.