Exhibit 11 Page 3 of 12
Press
OPER
to enter operation mode. Apply
low input power
and press PTT. Be sure you selected right
BAND, TUNE and LOAD knob positions. If you made some mistake, fault message appears:
Safety circuit stopped transmitting, fault LED
is
ON
(Fault code 4 is saving to the memory).
Release PTT, set proper positions of BAND,
TUNE and LOAD according to the table and
press PTT
again.
Another mistake can occur, if you have antenna connected to the wrong output. In such a case „
SWR
is too high
“ error message appears. Change antenna output using
S4
button.
This is not an optimal result, TUNE indicator
must go between both arrows. Use
TUNE
knob
to get maximum output power
and
LOAD knob
to
get indicator between
arrows.
Another example of not optimal result, TUNE
indicator must go between both arrows. Use
TUNE
knob
to get maximum output power
and
LOAD
knob
to
get indicator between
arrows
(in arrows direction)
.
This is a
good result
of tuning.
Now increase input power slowly and watch the display.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
