Parameter
Model MPPT3010
rated charging current 10A
Max PV voltage 30V
Max PV power 130W
rated load current 10A
system voltage 12V
Battery type Lead-acid(AGM,GEL,Sealed)
Over-voltage cut off load 16V
Hight -voltage protection 15.5V
Over-voltage recovery voltage 13.7V
Equalizing charge 14.5V
Boost charge 14.4V
Float charge 13.8V
Boost charge recovery 13.2V
load reconnect voltage 12.5V
Low voltage alarm 11.5V
low-voltage protection 11V
Working temperature -20
℃
--50
℃
Dimension 135*105*37mm
Weight 200g
Overheating
protection
The internal temperature of the controller is more than 80
℃
, the controller stops charging, and when the
temperature drops to 60
℃，
resume charging. If the overheating protection is repeated three times, the
charging will be stopped completely. If you need to recharge, you must reset manually or the next day
before you can recharge.
Reverse protection
Polar panel reverse connection
：
no charging, the controller unaffected.
Battery reverse connection
：
the fuse burns out and the controller unaffected.
Load reversal
：
load damage, controller may be damage
PV
overvoltage, overpower protection
PV overvoltage: >30V,stop charging
PV overpower: >130W,stop charging,Re-tested every 10 minutes
3.
load current>20A
,
The controller determines the load is short-circuited and turns off the load output directly.
4.
If the load protection occurs, turn on the load switch again and again after 120s, if the overload phenomenon
occurs more than 3 times repeatedly, turn off the load completely. Reset the machine before it can be reopened.
Warning
: the load should not be short-circuited directly, which may cause damage to the controller
The manufacturer shall not be liable for damages, especially on the battery, caused by use other than as intended or as
mentioned in this manual or if the recommendations of the battery manufacturer are neglected. The manufacturer shal
l not be liable if there has been service or repair carried out by any unauthorized person, unusual use, wrong installation,
or bad system design
Liability Exclusion
