4
SZ2-STU1/STU3
Fig. 5
Fig. 6
Allen wrench
storage position
Operation mistake
prevention ring
Clamping screws
NOMENCLATURE AND ASSEMBLY
1
Assembling the Stand
(Fig. 5)
SZ2-STU1
SZ2-STU3
Applicable
microscope body
Horizontal arm
Allen wrench
Clamping screws
(x 2)
Drop prevention ring
Column
Clamping screws
(x 2)
Base plate
Allen wrench
Connect the
ground lead wire.
*
Table clamp
section
Clamping screws
(x 2)
Allen wrench
Connect the ground
lead wire.
**
To maintain the ESD protection performance,
be sure to ground the equipment using the
following tools.
*
4 mm banana plug connection holes (x 4)
Bare ground lead wire connection screw (x 1)
**
Bare ground lead wire connection screw (x 1)
Attach the column by firmly tightening the screws using the Allen
wrench.
Insert the drop prevention ring below the horizontal arm, in close
contact with it.
}It is convenient to store the Allen wrench in the Allen wrench storage
position on the horizontal arm for future use.
2
Attaching the Bonder Arm
(Fig. 6)
1. Lift the operation mistake prevention ring on the shaft at the distal end of
the horizontal arm, and screw in the provided clamping screws into the
two screw holes by about half using the Allen wrench.
Insert the bonder arm from the bottom side all the way up until it is
stopped.
2. Tighten the clamping screws firmly using the Allen wrench. When you
remove your hand from the operation mistake prevention ring, it drops to
hide the screws.
Be sure to attach the bonder arm firmly with the screws. Otherwise,
it may rotate or drop and cause danger.
Bonder Arm
SZ2-STB1