10-004209-01EN [Q7750159], Rev. 2, May 2018
Chapter 4
112
An alternate mounting procedure is possible (see “Swivel Mount” on page 95 for
additional details).
4.3.4
Encoder
The left drive module’s motor encoder can be used to output encoder signals to an
instrument (see “Encoder Failure” on page 208 for additional details).
4.3.5
Handle
The handle on the left drive module is removed and attached in the same way as the
handle on the right drive module. See “Handle” on page 103 for instructions.
4.3.6
Dovetail Accessory Mount
The dovetail accessory mount on the left drive module works in the same way as the
mount on the right drive module. See “Dovetail Accessory Mount” on page 104 for
instructions.
4.4
Power Controller
The SteerROVER power controller converts power from a 100–240 VAC, 50/60 Hz,
3.5 A power source to 36 VDC, 8.9 A (see Figure 4-29 on page 113). A start/stop safety
circuit and physical ON and OFF push-buttons are integrated into the supply.
TIP
Summary of Contents for SteerROVER
