Olympus PPO-EP03, Instruction Manual

Page: 30 / 115

EN 30
EN
5. Handling After Shooting
Wash the Case with pure water
1 After use, clean the Case and Lens Port thoroughly with pure water as
soon as possible.
After use in sea water, soak it in pure water for a fixed time (30 minutes
to an hour) to remove any salt.
2 Take it out of the water and rinse with pure water.
Wipe off any waterdrop
Remove any drops of water from the Case and Lens Port. Use air or a soft
cloth not leaving any fibers to thoroughly wipe any waterdrop from the joint
between the front and rear lid, the palm grip, the open/close dial and other
operating parts.
After coming out of the water, do not detach the Lens Port from the Case or
open the Case. Instead, rinse the entire Case assembly in fresh water.
• Do not disassemble for cleaning.
• Drying the Case with salt adhered may impair the function. Always wash
off any salt after use.
• When waterdrops remain between the front and the rear lid, they may spill
to the inside when the Case is opened. Take special care to wipe off all
waterdrops.
• When removing this product from the Case, water droplets left in the region
of the O-ring of the product can be flicked onto the lens or camera body. In
the event that water droplets adhere to the lens or camera, do not panic -
wipe them off immediately with a dry cloth etc.
• When detaching this product, check that it has fully dried before
proceeding.
PPO-EP03_EN.book 30 ページ ２０１６年７月１５日 金曜日 午後５時４６分