E-15
En
Inserting the silica gel bag
Before sealing the Case, insert the
accessory silica gel bag (for prevention of
fogging) between the right side of the
electronic flash and the Case. Insert the bag
so that the longer glued side is on the
inside.
Open the Case.
Insert a finger below each buckle lock/unlock
lever as shown in the illustration. Pinch the
buckle hook and pull it up slowly.
Mounting the electronic flash
Mount the FL-36 flash on the Case
'
s hot shoe as shown in the illustrations.
Slide the electronic flash all the way into the hot shoe.
Turn the shoe lock dial of the electronic flash to clamp it.
To remove the FL-36 flash from the Case:
Turn the shoe lock dial of the electronic flash to unclamp it.
Hold the dial of the electronic flash firmly with a finger, and slide it out from the hot shoe.
：
• Be sure to switch the electronic flash OFF before loading.
• Do not apply excessive force when loading the electronic flash.
• When removing the electronic flash, hold it firmly so you don’t drop it.
CAUTION
：
• Insert the silica gel bag as far as it will go at the specified location and with
the specified orientation. If the orientation is incorrect, the silica gel bag will
catch when the Case is sealed and water will leak into the Case.
• If the bag is only inserted part of the way, it will get caught by the O-ring
when you try to seal the Case and water will leak into the Case
• Once silica gel has been used, its moisture absorption performance will be
impaired. Always change the silica gel when you open or close the Case.
CAUTION
PFL̲E01̲E 2005.5.25 4:36 PM ページ15
