DMTA-10040-01EN, Rev. E, February 2018
Chapter 5
152
5.
Repeat step 4 for each of the other shim thicknesses (1.5 mm, 1.0 mm, and
0.5 mm).
The instrument records a vertical line for each simulated paint thickness (see
Figure 5-44 on page 152).
Figure 5
‑
44 The vertical lines for different thicknesses
6.
Press and hold the REF SAVE key (
) to set the current signal as the reference
signal.
7.
Set the
V POS
(E key) to
50 %
, and then press the ERASE key (
).
The paint thickness setup is now complete and ready to be used in evaluations.
8.
Evaluate your subsequent paint thickness reading using the vertical reference
marks (see Figure 5-45 on page 153).
If necessary, you can increase your resolution by calibrating with a greater
number of thinner shims.
Summary of Contents for nortec 600
