DMTA-10026-01EN, Rev. D, January 2015
Chapter 7
132
4.
Press
[ID#]
again, and edit the ID value (see Figure 7-16 on page 132).
Figure 7-16 Editing the ID number
5.
Press
[MEAS]
to return to the measurement screen with the new active ID.
To replace a thickness reading, it is easier to save a new measurement at the desired
ID in the measurement screen. If you do not want to save a measurement at a specific
ID, press
[SAVE]
in the measurement screen when you are not taking a measurement.
This stores an
LOS
condition and -.--- at the specific ID number.
7.6
Generating Reports
The Magna-Mike 8600 can generate data reports without having to connect to a
computer. The following reports are available:
File summary
Shows basic statistics for the file (minimum thickness, maximum thickness, high
and low alarm conditions along with the mean, median, and standard deviation).
Minimum/Maximum summary
Shows a list of ID number location that have the minimum and maximum
thickness in a file.
TIP
Summary of Contents for Magna-Mike 8600
