DMTA017-01EN, Rev. F, August 2016
Scanner Assembly and Setup
19
2. Scanner Assembly and Setup
This chapter explains how to adjust parts on the HSMT-Compact scanner (for
example, the wheel-assembly position on the frame), and how to set up the scanner
for inspection.
2.1
Changing the Frame Configuration
The frame configuration can be changed as follows:
•
The frame section between the wheels can be changed to increase or decrease the
distance between the wheels. This is accomplished using frame sections of
different lengths.
OR
•
The wheel-assembly position can be adjusted on the frame; it can be loosened and
moved along the frame section. As such, the wheel assembly can be temporarily
removed, and then reinstalled so that the frame and the probe extend outside the
limits of the wheels, which is ideal for hard-to-reach areas, such as pipe-to-
component welds (see Figure 1-6 on page 18).
To change the frame section between the wheels
1.
On the end of the scanner displaying the company name, perform the following
steps:
a)
Using a hexagonal key, remove the two screws that attach the frame section to
the wheel assembly (see Figure 2-1 on page 20).
b)
Remove the wheel assembly from the frame.
c)
To facilitate reassembly, remove the T-nut, and then install it onto the new
frame section.
Summary of Contents for HSMT-Compact
